97-8
Page 3 of 15
TECHNICAL DATA
UNCRATING
Carefully lay the crate on its bottom.
Remove all screws retaining cover to vehicle
base. Tip cover toward front of vehicle. There is a
notch at the front of crate.
1. Notch
Detach parts to be installed (e.g. skis, windshield)
from the vehicle and its base.
Cut locking ties retaining windshield. Slowly pull
out metal strip.
When this metal strip is under the seat loosen 2
or 4 nuts retaining the seat before pulling out the
metal strip.
Detach ski legs from crate. Keep ski leg bolts, slid-
er cushions to bolt skis to ski legs. Discard crating
spacers and nuts.
PREDELIVERY KIT
P/N
MODELS
580 6472 00
FORMULA III LT
MACH Z LT
◆
WARNING
Torque wrench tightening specifications
must be strictly adhered to. Locking devices
(e.g. Iock tabs, elastic stop nuts) must be in-
stalled or replaced by new ones, where
specified. If the efficiency of a locking device
is impaired, it must be renewed.
-
CAUTION
Allowing the crate to drop may cause seri-
ous damage to the vehicle.
-
CAUTION
Failure to lift seat might result in leatherette
damage.
-
CAUTION
Make sure vehicle is properly supported be-
fore removing ski legs and rear suspension
from crate brackets.
A15A0OA
1
