sitrex TR/6-S, Assembly, Use And Maintenance

Page: 27 / 48

27
13) DANGER
Extend the hose 1 along drawbar B toward the front of the machine above to hose 7
already assembled. Extend the hose 2 along drawbar B toward the front of the
machine parallel to hose 1. Extend the hose 2 along hose 10 already assembled
toward the cylinder E. Connect the hose 2 to the cylinder E using washers 5 and
screw 9. Fasten the hoses 1-2 using hose collars 12, plate 13 and screw 14. Connect
the fitting 3 to the hose 1. Connect the hose 4 to the fitting 3. Connect the hose 4 to
cylinder check valves C using washers 5, fitting 6 and screw 9.
Connect the hose 11 to the fitting 3. Extend the hose 11above hose 10 already
assembled toward the cylinder check valves D. Connect the hose 11 to the cylinder
check valves D using washers 5 and screw 9. Connect the washers 15 and the quick-
release couplings 16 to the male ends of hoses 1-2-7.
Note: before fully fastening hoses 1-2-4-7-8-10-11, make sure that the line of each
hose from one end to the other is not twisted and/or does not have sharp bends or
kinks that cause it to be crushed or to have an unpleasant appearance.
In this step, you will use:
Item 1: 1 hose, ¼”, length 5350 (211”)
Item 2: 1 hose, ¼”, length 8100 (323”)
Item 3: 1“T“ fitting male ¼“
Item 4: 1 hose, ¼”, length 420 (17”)
Item 5: 7 washers ø3/8”
Item 6: 1 fitting male-female 3/8“
Item 7: see preceding step
Item 8: see preceding step
Item 9: 3 screw-type coupling 3/8”
Item 10: see preceding step
Item 11: 1 hose, ¼”, length 2350 (93”)
Item 12: 2 hose collars ø16 (0.63”)
Item 13: 1 plate
Item 14: 1 screw M8x35 (0.31 x 1.38”)