sitrex TR/6-S, Assembly, Use And Maintenance

Page: 13 / 48

13
2) DANGER
Before attaching the wheel units 1, brush pin B and spring pins 5 with grease.
Insert the nylon bushings 3 into the proper seats C-D. Place spacer 2 on the pins B of the
wheel units 1. Insert the wheel units 1 into the proper seat C. Attach the lever 4 into the pins B
of the wheel units 1 using the spring pins 5. Attach the grease nipples 6 to the proper seat C.
Insert the wheel units 1 into the proper seat D. Attach the flange 7 into the pins B of the wheel
units 1 using the spring pins 5. Attach the plate with bolt 8 underneath flange 7. Attach the
brake plate 9 over flange 7, inserting the brake plate pins F into the holes in the plate with bolt
8 and into holes E in the sections. Place the spring 10, and washer 11 over the plate with bolt 8
and put nut 12 on the bolt.
Note: the more spring 10 is compressed by tightening nut 12, the more the turning of the
wheel is braked, therefore check that it is adjusted properly when the machine is to be
operated . Attach the grease nipples 6 to the proper seat D.
In this step, you will use:
Item 2: 2 spacers ø50-76x5 (1.97”x3”)
Item 3: 4 nylon bushings ø50-60x50 (ø1.97”-2.36x1.97”)
Item 5: 2 spring pins ø10x80 (0.4”x3.15”)
Item 6: 2 grease nipples M8 (0.31”)
Item 10: 2 springs ø5-30x45 (0.20”-1.18”x1.77”)
Item 11: 2 washers ø12-36x4 (ø0.47”-1.42x0.16”)
Item 12: 2 nuts M12 (0.47”)