sitrex TR/6-S, Assembly, Use And Maintenance

Page: 25 / 48

25
12) DANGER
Fasten the flow divider 1 and the hose support 2 to frame A using bolts 3 and nuts
4.
Apply washers 5 and nipples 6 to three holes on the flow divider 1. Connect the
hose 7 to nipples 3. Extend the hose 7 along the drawbar B. Connect the hose 8 to
nipples 3. Connect the hose 8 to cylinder check valves C using washers 5 and
screw 9. Connect the hose 10 to nipples 3. Connect the hose 10 to cylinder check
valves D using washers 5 and screw 9. Note: before fully fastening hoses 7-8-10,
make sure that the line of each hose from one end to the other is not twisted and/or
does not have sharp bends or kinks that cause it to be crushed or to have an
unpleasant appearance.
Hoses 7-8-10 will also be in the following steps.
In this step, you will use:
Item 3: 2 bolts M6x140 (0.47”x5.51”)
Item 4: 2 nuts M6 (0.24”)
Item 5: 7 washers ø3/8”
Item 6: 3 nipples 3/8”-1/4”
Item 7: 1 hose, ¼”, length 5200 (205”)
Item 8: 1 hose, ¼”, length 460 (18.1”)
Item 9: 2 screw-type couplings 3/8”
Item 10: 1 hose, ¼”, length 2450 (97”)