sitrex TR/6-S, Assembly, Use And Maintenance

Page: 16 / 48

16
5) DANGER
Before attaching the wheel unit 3, brush pin B and spring pin 5 with grease.
Insert the nylon bushings 1 into the proper seats A. Place spacer 2 on the pins B of the wheel
units 3. Insert the wheel units 3 into the proper seat A. Attach the flange 4 into the pins B of
the wheel units 3 using the spring pin 5. Attach the plate with bolt 6 underneath flange 4.
Attach the brake plate 7 over flange 4, inserting the brake plate pins F into the holes in the
plate with bolt 6 and into holes E in the support. Place the spring 8, and washer 9 over the
plate with bolt 6 and put nut 10 on the bolt.
Note: the more spring 8 is compressed by tightening nut 10, the more the turning of the wheel
is braked, therefore check that it is adjusted properly when the machine is to be operated.
Attach the grease nipple 11 to the proper seat.
In this step, you will use:
Item 1: 2 nylon bushings ø50-60x50 (ø1.97”-2.36x1.97”)
Item 2: 1 spacers ø50-76x5 (ø1.97”-3x0.2”)
Item 5: 1 spring pin ø10x80 (0.4”x3.15”)
Item 8: 1 spring ø5-30x45 (0.20”-1.18”x1.77”)
Item 9: 1 washer ø12-36x2.5 (ø0.47”-1.42x0.1”)
Item 10: 1 nut M12 (0.47”)
Item 11: 1 grease nipples M8 (0.31”)