6-11
A tunnel profile defined as "Incoming Only" cannot be used in an outgoing VPN
profile.
"Static entry not found"
An attempt was made to locate an entry which does not exist.
"Statistics Cleared"
The Broadband Router has completed a clear statistics operation on the link selected
in the System Status Monitoring Window.
"Static DHCP Entry Not Found"
A DHCP entry must be selected to “Edit” or “Delete”.
"Static routes to single user profiles not allowed"
You have entered an illegal configuration. Static routes can only be configured over
Internet Access or Remote Office Access profiles. You cannot configure a static route
to a Single User Dial-in profile.
"System received incompleted user's command. Please try
again"
An internal error has occurred. Please retry the operation.
T
"The system is disconnecting"
A "disconnect" button is pressed, while the system is in the process of disconnecting
an active modem link.
"The system time has been configured successfully"
The time has been configured successfully.
"The Gateway IP Address has been set as the IP Default Route"
The Internet access profile has been configured in the router and the configured ISP
Gateway IP Addrress is now set as the IP Default Route
"This interface has been configured to support a Remote Office
profile. You must use the Command Line Interface for this type of
configuration"
An EWAN profile has been configured to support Office-to-Office communication.
This type of profiles can only be configured using the Command Line Interface.
“This operation will cause a system reset upon completion. All
unsaved configuration changes will be lost. ”
A "Download Firmware" operation through a directly connected Command Line
Interface session will cause a system reset after the operation is complete. This
