3-21
Note:
When you click
APPLY and TEST
, the Wireless Router attempts to place
a call to the remote LAN and log in. Watch the Message Window for any messages.
Advanced Options for Remote Office Profiles
Note:
The
IPX
options shown in this screen only appear if you also selected
Share
NetWare (IPX) Resource
on the
ARM Customization
screen
Step 1
Enter the following information:
STAC Compression:
allows outgoing data to be compressed to achieve
higher throughput, and compressed incoming data to be recognized. The
ability to use compression depends on the capabilities of the ISP
Idle Timeout:
the number of seconds of inactivity over the connection.
When this value is reached, the Wireless Router will disconnect the call.
You can set the idle timeout from
0
to
3600
seconds. The default setting is
300
seconds. If you select
0
, the connection will never time out.
Enable IP:
select Yes to allow IP routing over a connection using this
profile
IP RIP
: enable or disable IP Routing Information Protocol.
IP RIP Version
: select
RIP-I
if the Routing Information Protocol,
version 1 is to be used, or
RIP-II
if the Routing Information Protocol,
version 2 is to be used for this connection.
Note:
The use of RIP-I or RIP-II depends upon the System-wide setting of
RIP. If the system-wide setting is Disable, the RIP setting for all connection
profiles will be disabled. If the system-wide setting is RIP-I, only RIP-I may be
selected in any profile. If the system-wide setting is RIP-II, either RIP-I or RIP-II
