Siruba ASP-EBJ100, Instruction Book

Page: 23 / 56

5. Reset the starting position of
the band. (when there is an
interruption.)
(1) The setting of band starting
position will run automatically
when you turn on the power
first time.
(2) In case of reloading the
band or resuming from an
interruption, to make sure the
circling band length is correct,
press and hold RESET
③
for
2~3 seconds. The machine
will cut off a short band and
to restart the measuring.
6. Auto (Continuous) operation.
(1) Press START
④
. The machine will pull out the band and form a circle to the ready for sewing position. Then it
pauses.
(2) Check if the overlapping matches the setting you have done previously.
(3) Press START
④
again to complete the sewing. The machine will run continuously until it completes the target
quantity.
(4) Press CYCLE STOP
⑤
, the machine will stop after the current cycle completes.
(5) To stop the operation immediately, press EMERGENCY
⑥
. The indicator STOP
⑦
will be on. To resume the
operation, please refer to the chapter TROUBLE SHOOTING.
7. Single Cycle operation.
(1) Press START
④
. The machine will pull out the band and form a circle to the ready for sewing position. Then it
pauses.
(2) Check if the overlapping matches the setting you have done previously.
(3) Press CYCLE STOP
⑤
to complete the work cycle. And the machine stops later.
④
⑤
⑥
③
P13