Siruba ASP-EBJ100, Instruction Book

Page: 18 / 56

Part 1: Initial Mechanical Setting (Preset done by maker. No need to apply step 1~5 unless a significant overlapping
difference, i.e. greater than 11mm).
For general operation setting, simply go to control panel setting (Part 2)
1. Loosen screw
①
, move the left cylinder seat
②
position to the desired position. (default value set to the 3rd red
mark
③
).
2. Loosen screw
①
, move the right cylinder seat
⑤
position to the desired position. (default value set to the 3rd
red mark
⑥
).
3. Turn on the machine, and press START.
4. The 2 ends of the band (
⑥ / ⑦ ) should meet at the center red line ⑨ of the feeding plate. If not, repeat step 1
and 2 to adjust accordingly.
5. All the mechanical parts are set and tested in our factory before delivery.
SETTING THE BUTTED SEAM AND OVERLAPPING AREA
 
⑥ ③
①
④
⑤ ②
P8