6 Installation and startup
6.4 Initial startup
Sirona Dental Systems GmbH
Operating Instructions CEREC AC
32
2.
Then pull out the voltage selection insert and turn it so that the
correct line voltage value is visible after it is reinserted.
3.
Reinsert the fuse module.
6.4.4
Plug connections
1.
Connect the unit to the line voltage with the power cord.
2.
Carefully plug the connector of the camera cable into the Bluecam,
watching out for the guide nose and screw it down tight clockwise.
3.
Check the plug connections of the power supply and the Bluecam.
The camera cable must be connected to the Bluecam and securely
screwed on. The Bluecam always remains connected.
NOTE
The Bluecam is a high-precision optoelectronic scanning instrument
for non-contact impression taking which requires careful handling.
Incorrect handling (impacts, dropping) leads to failure of the Bluecam.
➢ Always deposit the sensitive Bluecam in its holder!
4.
If the Bluecam must be replaced, carefully plug in the connector,
watching out for the guide nose, and screw it down tight.
Notes on network installation
The network card is installed.
The cable with the RJ-45 connectors establishes the network
connection. The network software and the driver for the network card
must be installed by your network administrator.
The acquisition unit is equipped with a WLAN card that is preconfigured
for operation with an MC XL milling unit. The integration of the
acquisition unit into the practice network with the aid of the WLAN card
is not supported by Sirona.
Summary of Contents for cerec ac
Page 83: ......
