10
INSTALLING THE FOAM GASKET
Before installing the cooking hob in its appropriate
position in the worktop, apply the adhesive gasket in
expanded polyurethane supplied with the product to
the lower part of the cooking hob.
INSTALLATION PROCEDURE
WARNING
The gasket should be attached to the appliance in
the following way:
• Remove the protective film from the gasket.
• Then, attach the gasket to the lower side of
the glass, approximately 2-3 millimetres from
the edge.
• The gasket must be attached along the entire
length of the glass edge and should not over-
lap at the corners.
• When installing the gasket, make sure that
the glass does not come into contact with
any sharp objects.
• The worktop must be perfectly level.
• Place the cooking hob into the previously real
ised opening in the worktop.
• Press the induction hob down forcefully onto
the worktop, in correspondence to the edges
of the cooking hob.
• If the downdraft is not perfectly aligned with
the induction hob, adjust the alignment
screws (Fig. 10A) on the right and left of
the product. Screw in the screws to lift
the downdraft and unscrew to lower the
downdraft.
• Before the installation, the screws indicated
in Fig. 10B must be unscrewed as much as
possible so as to keep the downdraft near to
the rear part of the kitchen cabinetry.
• If the downdraft is not centred correctly with
the cooking hob after the installtion has been
carried out, utilise the adjustment screws Fig.
10B to shift is forwards by screwing in the
screws on both the right and left side of the
product.
1. Check that the downdraft inside the kitch unit
is perfectly vertical. FIx it utilising the brackets
supplied (Fig.11)
2. Permanently fix the downdraft utilising the
two screws indicated in Fig. 12
3. Connect the electrical cables of the
downdraft as shown in Fig. 13 and then carry
out the connection to the mains electricity in
accordance with the information reported on
the relative technical date plate.
Position the metal box containg the electronic
components in an easily accessible position
in the case of any servicing requirements.
Unattended cooking on a hob with fat or oil can
be dangerous and may result in fire.
Summary of Contents for S-DDH1.1
