10.4
SNMP
Network > SNMP
What this tab is for
On the SNMP tab, you can turn on SNMP and configure its settings to get the camera status,
parameters and alarm related information and manage the camera remotely when it is
connected to the network.
Before you continue
Before you set up SNMP, download and install the SNMP software and configure it to receive
the camera information via the SNMP port. By setting the Trap Address, the camera can send
the alarm event and exception messages to the surveillance centre.
Note: The SNMP version you select on the SNMP tab should be the same as that of the
SNMP software. The SNMP version that you select must meet the security level you require.
SNMP v1 provides no security. SNMP v2 requires a password for access. SNMP v3 provides
encryption and if you use v3, an HTTPS protocol must be enabled.
To turn on SNMP
1
Select the check box of the required SNMP version.
2
Configure the SNMP settings.
The settings you configure here should correspond with the settings of the SNMP
software.
3
Click Save.
Network
51
