68
4. Bei Betätigung der Außenbedienung für
den Dreipunktanbau nicht zwischen Traktor
und Gerät treten!
5. In der Transportstellung des Gerätes immer
auf ausreichende seitliche Arretierung des
Traktor-Dreipunktgestänges achten!
6.
Bei Straßenfahrt mit ausgehobenem Gerät
muß der Bedienhebel gegen Senken
verriegelt sein!
4. When operating outside lift-control of three
point hitch, don't stay between tractor and
machine!
5. When machine in transport position, adjust
side movement of three point hitch!
6. When driving on the road with lifted
machine, insure the lever of hydraulic
control against unintentional drop!
Zapfwellenbetrieb
1. Es dürfen nur die vom Hersteller
vorgeschriebenen Gelenkwellen verwendet
werden!
2.
Schutzrohr und Schutztrichter der
Gelenkwelle, sowie Zapfwellenschutz –
auch geräteseitig – müssen angebracht
sein und sich in ordnungsgemäßem
Zustand befinden!
3. Bei Gelenkwellen auf die vorgeschriebenen
Rohrüberdeckungen in Transport- und
Arbeitsstellung achten!
4. An- und Abbau der Gelenkwellen nur bei
ausgeschalteter Zapfwelle, abgestelltem
Motor und abgezogenem Zündschlüssel!
5. Bei Verwendung von Gelenkwellen mit
Überlast- oder Freilaufkupplung, die nicht
durch die Schutzeinrichtung am Traktor
abgedeckt werden, sind Überlastbzw.
Freilaufkupplungen geräteseitig
anzubringen!
6. Immer auf richtige Montage und Sicherung
der Gelenkwelle achten!
7. Gelenkwellenschutz durch Einhängen der
Ketten gegen Mitlaufen sichern!
8. Vor Einschalten der Zapfwelle sicherstellen,
daß gewählte Zapfwellendrehzahl des
Traktors mit der zulässigen Drehzahl des
Gerätes übereinstimmt!
9. Bei Verwendung der Zweiwegzapfwelle
beachten, daß die Drehzahl
fahrgeschwindigkeitsunabhängig ist und die
Drehrichtung sich bei Rückwärtsfahrt
umkehrt!
P.T.O. SHAFT drive (only for
implements driven by a P.T.O
Shaft)
1. Use only P.T.O. Shafts prescribed by the
manufacturer!
2. PTO shaft - protection tubes and protection
pots, driveshaft protection on the tractor,
and on inlet shaft on the machine must be
on their places and in good condition!
3. Take care about the prescribed P.T.O.
Shaft tube overlap in transport and working
position!
4. P.T.O. Shaft can only be mounted when the
P.T.O. Shaft connection and engine are
switched off and the ignition key is pulled
out!
5. When using the P.T.O. Shafts with overload
and/or free-wheel clutch, which are not
covered by a protection on the tractor, put
the overload or the free-wheel clutch on the
machine side!
6. Always pay your best attention to proper
mounting and securing of the P.T.O. Shaft!
7. Secure the P.T.O. Shaft protection against
rotating by a chain!
8. Before switching on the P.T.O. Shaft make
sure, that the selected RPM and rotating
direction of the tractor connection match
with the allowed RPM and rotating direction
of the machine!
9. When using two-way PTO shaft take into
consideration that RPM depend of driving
speed and rotation direction at reverse drive
Invert!
Summary of Contents for SPIDER 600/6 ALP
