Sinterit LISA PRO User Manual | 8
WARNING!
•
Use only the Power cable supplied with the product.
•
Do not use power cables from other devices! Using the power cables from
other devices or connecting the power cables supplied with the product to
other devices may cause fire or electric shock.
•
The power cable should be placed in such a place that they are not rubbed,
cut, pulled or twisted.
•
Pay special attention to the fact that the Power cable is not bent at the points
of connection of the printer.
•
During use, mind the power supply cables and avoid crushing or pulling these.
•
Periodically check the mains power cable to ensure it is not damaged.
•
In the event of the cable being replaced, make sure it is protected against
water spray and check mechanical strength.
•
Disconnect the Power cable whenever it is planned to shift/transfer the
machine.
WARNING!
In the following situations, unplug the product from the power supply and contact
with Sinterit Support:
•
the power cord or plug is damaged;
•
some liquid got into the product;
•
the product has been dropped or the case has been damaged;
•
the product does not operate properly or clear changes in efficiency have been
observed.
STOP!
•
Never touch electric wires, switches, buttons, etc. with wet hands.
•
Never pull the machine by means of the power cable. When connecting/
disconnecting the plug to/from the power socket always hold the cover, not
the cable.
•
In the event of the cable being damaged, the machine must not be used.
•
Never disassemble, modify or repair the power cable, plug, devices inside the
printer, except as described in the product manual.
•
Do not place objects on the Power cable.
•
Do not place Power cable in a path where people will have to walk or run.
ATTENTION!
It is recommended to use UPS units that, in the case of a momentary power failure, will allow the
printing process to finalise.
ATTENTION!
•
The printer must be connected to a grounded outlet to prevent electric shock
in the event of a fault.
E. SAFETY REQUIREMENTS DURING USING THE SINTERIT LISA PRO PRINTER
WARNING!
Before printing always make sure the printer is free of all external materials such as debris, oil,
equipment and other objects that could affect the operation and cause injury to persons.
