Sinterit LISA PRO User Manual | 32
Temperature management suggestions
•
The possibility to adjust the temperature is also provided in the Sinterit STUDIO software.
•
On the machine, this option is depicted using + and – buttons which increase or decrease the
temperature by 0.5 [°C] (maximum /- 5 [°C]). In Sinterit STUDIO, this option is depicted
using PRINT SURFACE TEMPERATURE Offset drop-down menu [°C].
•
These options are used to increase the level of cake welding (printouts more straight but less
detailed) or to decrease the level of cake welding (cake becomes more powdery, it is easier to
clean it up but printouts can be distorted; printout details have better quality).
•
Another calibration option is to change the laser power. This change is only possible on the
level of Sinterit STUDIO. In the program menu, it can be found as LASER POWER RATIO (1.0
by default).
•
The laser intensity is raised by increasing the value by 0.01 and lowered by decreasing (also by
0.01). The acceptable calibration scope of laser multiplier is 0.5-3.0.
•
As the laser gets weaker, the printout durability gets lower as well, however, the quality of
details gets better. Similarly: an increase of laser power strengthens the printout but weakens
the quality of details.
These remarks apply to the polyamide materials (e.g. PA12 SMOOTH and PA11 ONYX). In case
of FLEXA materials, an increase in laser power results in a printout stiffening (up to a certain,
maximum level).
ATTENTION!
Do not lower the temperature inside too quickly. The permissible standard is 0.5 [°C] on one layer.
ATTENTION!
During printing, if the smoke, irritating smell or other alarming circumstances take place,
press the
Safety button
10
. It will immediately cut off the power from the printer.
However, remember that it is impossible to open the printer (e.g.: by lifting the Lid), until the
temperature inside will not drop below 50[°C] and the UNLOCK LID option becomes available.
ATTENTION!
While the printer is working do not touch any other elements besides the LCD screen
2
, the Safety
button
10
, the USB port
8
and the Power switch
15
.
