A. Basic Function
11
Segmented compensation value is found according to the wrong mechanical
coordinate, thus there is big error of the displayed coordinate.
The method of finding mechanical origin is as follows:
1.Move the raster ruler to the position which is initially set up as the
mechanical origin, and then set up Segmented compensation. When inputting
the quantity of compensation segment and the compensation length, do not
make any change, and press directly to skip. Enter into the interface for
choosing compensation method, press . The interior of digit display meter
handles automatically. At this time, directly press key to quit the Segmented
compensation setup, and finish finding the mechanical origin.(Remarks: It is
applicable to setting up parameters according to sketch map 1)
2.Firstly move the raster ruler to the smallest value, and then set up
Segmented compensation. When inputting the quantity of compensation
segments and the compensation length, do not make any change, and
press .directly to skip. Enter into the interface for choosing compensation
method, press ,to enter X axis to find the status of absolute zero.
Move the raster ruler towards the positive direction. When the absolute zero is
found, it is the mechanical origin. The interior of digit display meter handles
automatically. At this time, directly press key to quit the Segmented
compensation setup, and finish finding the mechanical origin.(Remarks: It is
applicable to setting up parameters according to sketch map 2)
Note: When find the mechanical origin, the user-coordinate will resume.
Advise: find the mechanical origin before start work after power on to
assure the coordinate origin of the machine tool can match the value in the
digit display meter.
10. Power Interruption Memory
During the processing of a working piece, there may occur power
interruptions or needed temporary turnoffs, the digital display box will
automatically store the working state (such as the working mode in every axis,
displayed data and the linear error compensation factor) just before every
interruption event in its memory. Every time when the machine is turn on again,
the digital display box will recover to its working state just before the interruption
event after self checking, and the valve just before the interruption (turn off) event
will recover, and the processing will continue.
Summary of Contents for SDS2MS
Page 4: ...Illustration of Panel and Keyboard 1...
Page 21: ...B Smooth R 13 B Smooth R Iran agent Tel 021 66 3939 00 Mob 0912 147 3023 www Sino ir...
Page 30: ...C Simple R 22 C Simple R Iran agent Tel 021 66 3939 00 Mob 0912 147 3023 www Sino ir...
Page 65: ...J N3 Function 57 J N3 Function Iran agent Tel 021 66 3939 00 Mob 0912 147 3023 www Sino ir...
