A) Deleting a Transmitter
If a motor has two or more transmitters memorized it is possible to delete a transmitter from its
memory. On the transmitter you want to keep, press and hold the
Program Button
(about 3 seconds)
until the motor jogs forward and back. Press and hold the
Program Button
(about 1 second) on the
transmitter you want to delete. When the motor jogs forward and back the transmitter is deleted.
Note
, if the transmitter was not in the receiver’s memory, it will be added instead of deleted.
B) Clearing the Memory of Old Transmitters and Adding a New Transmitter
If all a motors transmitters are lost or damaged, it is possible to clear the old memorized codes from
memory and add the new transmitter. Perform a double power cut in the following sequence:
1) Power off for at least 2 seconds
2) Power on for 5 to 15 seconds
3) Power off for at least 2 seconds
4) Power on
The motor is now in a
Temporary Programming Mode
(last for 2 minutes). The motor will attempt to
rotate in one direction for 3 seconds unless it is at a limit .
NOTE: THIS IS NOT “FACTORY MODE”.
Press and hold the
Program Button
of
any
transmitter
for more than 5 seconds. When the motor jogs forward and back, release the
Program Button
. The
memory of the motor’s receiver is now cleared of the old transmitters and the new transmitter is added.
If a motor or motors are entered into
Temporary Programming Mode
by mistake it can be canceled
by pressing on the up, stop or down button of any transmitter that the motor has memorized. The motor
will also return to normal operating mode if left for 2 minutes.
C) Returning to Original Factory Mode (Deleting All Transmitters)
Note: When the motor is in Factory Mode is the only time the direction of rotation can be changed
It is also recommended that the limits be set while the motor is in factory mode as it takes
continuous pressure on the transmitter button to move the motor
To return the motor to Factory Mode, make a double power cut as described in section (B). Press and
hold the
Program Button
of an
already recorded transmitter.
The motor will jog forward and back.
Immediately release the
Program Button
. The motor is now in
Factory Mode
. All transmitters are
cleared from memory. The motor will not respond until both the up and down buttons are pressed
simultaneously on a transmitter held within 10 feet. In
Factory Mode
, the motor will move only as long
as the transmitter button is held down. The direction of rotation can now be changed.
Trouble Shooting
-Motor goes up when down is pressed.
Go to step (C) listed below
Setting Direction of Rotation.
-Can not change the Direction of Rotation.
Make sure to hold the transmitter within 10 feet of the
motor head. Confirm the motor is in”
Factory Mode
”
-
Can not get the motor to memorize the 1st transmitter.
When the motor is in “
Factory Mode
” the
transmitter range is 10 feet. Make sure to hold the transmitter within 10 feet of the motor head
and hold down the
Program Button
until the motor jogs forward and back.
-Lost transmitter
. Go to step (B) listed below to clear old transmitters from memory and add new
transmitter.
-
Motor does not respond to transmitter.
Make sure the motor has been awaken by pressing the up
and down buttons on the transmitter simultaneously until the motor jogs forward and back.
Problems
Solutions
R
25
Summary of Contents for TSA Hz 2
Page 1: ...R Hz 2 Radio Control Systems Programming Manual www simu com ...
Page 25: ......
Page 26: ......