Simu TSA Hz 2, Programming Manual

Page: 12 / 26

Multiple motors to one wireless switch.
There is no limit to the
number of motors you can program to one switch. The only limitation is the
range a transmitter can reach. This is approximately 70 feet through walls
and up to 100 feet in open air.
1) Setting Direction of Rotation
The motor will be in “ Factory Mode ” right out of the box when power is
connected. To prepare the motor for programming, press the transmitter
up and down buttons simultaneously until motor jogs forward and back
(example 1) .
Hold the transmitter within
10 feet of the moto r and press the up button
(example 2) . If the motor rotates in the up direction, move to step 2
programming.
If the motor, goes down instead of up, press and hold the stop button
until the motor bounces forward and back
(example 3) . Confirm the
up button now makes the shutter go up.
2) Programming the Transmitter
You can now proceed to the up and down limit settings.
Hold the transmitter within 10 feet of the motor head (example 4) .
Press and hold the Program Button (about 1 second) until the motor
jogs forward and back. Transmitter range will now be approximately 100 ft.
3) Disconnect the Power to Motor
After the above steps are completed, disconnect the power to the motor.
Proceed to the next motor using these same steps listed above with the same
transmitter switch.
4) Connect the Power to Motor
Once all the motors are completely programmed and limits are set. Reconnect
the power to all the motors.
Hz 2 Type 5 / DMI Operator
Scenarios
R
Program Button
Press the up button
Press the up and down
button simultaneously to
awake the motor.
If the shutter goes down instead
of up, press and hold the stop button
until the motor jogs forward then back.
(example 2)
(example 1)
(example 3)
(example 4)
FCC
Label
Back of transmitter
13