Testing the peripheral equipment
133
851--164300 / C
10.10
Current meter system
Observe the following procedure to test the Current Meter system
interface.
1
Access the
I/O Setup
menu.
→
A procedure for this is located on page 121.
2
Select
Sensors
in the
I/O Setup
menu, then
Current meter
,
and finally
Kaijo.
3
Observe the
Sensor Config
submenu appears at the bottom
of the menu field.
4
Check that the settings in the
Sensor Config
submenu
correspond to your requirements for the serial line.
5
Press
Close
to exit the
Sensor Config
menu.
6
Select the
Objects
menu, and check that the Buoy readout
(
F
) is shown.
7
Select one of the buoys in the
Objects
menu, and verify that
the buoy data is shown in the dialogue below the menu.
Summary of Contents for SH80 - REV C
