Simrad SH80 - REV C, Installation Manual, Page: 141 / 200

Testing the peripheral equipment
125
851--164300 / C
1 Access the I/O Setup menu.
2 Select Sensors in the I/O Setup menu, then Speed and
finally Speed Log .
3 Observe the Sensor Config submenu appears at the bottom
of the menu field.
4 Change the settings in the Sensor Config submenu to suit
your requirements for the serial line.
- Remember to set correct baud rate, and set
Talker to
None .
5 Press Close to exit the Sensor Config menu.
6 Check that the speed readout in the Status menu corresponds
to the vessel’s speed log.
Related topics
→
Access to the I/O Setup, page 121.
Speed data from (D)GPS
If the GPS is used for the speed data input, wait with this test until
the GPS position data are tested.
Observe the following procedure to test the GPS speed input:
1 Access the I/O Setup menu.
2 Select Sensors in the I/O Setup menu, then Speed and
finally Speed Log .
3 Observe the Sensor Config submenu appears at the bottom
of the menu field.
4 Change the settings in the Sensor Config submenu to suit
your requirements for the serial line.
- Remember to set correct baud rate, and set
Talker to GP .
5 Press Close to exit the Sensor Config menu.
6 Check that the speed readout in the Status menu corresponds
to the GPS speed.
Related topics
→
Access to the I/O Setup, page 121.