![background image](http://html.mh-extra.com/html/silverline/951855/951855_original-instructions-manual_1273356011.webp)
www.silverlinetools.com
11
2400W Angle Grinder 230mm
951855
Maintenance
WARNING
: Always remove the plug from the mains power supply before carrying out any
maintenance/cleaning.
Cleaning
WARNING
: ALWAYS wear protective equipment including eye protection and gloves when
cleaning this tool.
• Keep your tool clean at all times. Dirt and dust will cause internal parts to wear quickly,
and shorten the device’s service life
• Clean the body of your machine with a soft brush, or dry cloth
• Never use caustic agents to clean plastic parts. If dry cleaning is not sufficient, a mild
detergent on a damp cloth is recommended
• Water must never come into contact with the tool
• Ensure the tool is thoroughly dry before using it
• If available, use clean, dry, compressed air to blow through the ventilation holes
(where applicable)
• Do not clean with organic solvents which is harmful to the power tool body material
Brushes
• Over time the carbon brushes inside the motor may become worn
• Excessively worn brushes may cause loss of power, intermittent failure,
or visible sparking
• To replace the brushes, remove the Brush Access Covers (10) from both sides of the
machine. Remove the worn brushes and replace with new. Replace Brush
Access Covers
• After replacing, check that the brushes can move freely in the brush holder and run the
tool without load for approximately 15 minutes before use
• Alternatively, have the machine serviced at an authorised service centre
Disposal
Always adhere to national regulations when disposing of power tools that are no longer
functional and are not viable for repair.
• Do not dispose of power tools, or other waste electrical and electronic equipment
(WEEE), with household waste
• Contact your local waste disposal authority for information on the correct way to
dispose of power tools
951855_Z1MANPRO1.indd 11
09/11/2016 09:59