31
GB
3. Place the bag in the device. For this pur-
pose, the end of the film bag must be
positioned just before the rear reference
ridges
12
and the side reference ridg-
es
13
.
4. Ensure that there are no creases in the
film bag - especially above the welding
wire
15
.
5. Close the lid
17
and press it down
slightly.
6. Press the button
1
to switch the de-
vice to standby. The LED is lit.
7. Press the button
5
. The LED is lit. The
film bag is first vacuum-packed and
then sealed.
The LED goes out when the process is
complete.
NOTE:
if the LED
5
does not go out and the
noise of the vacuum pump does not stop, de-
spite the fact that no further air is being
sucked out of the film bag, cancel the pro-
cess. Check that the film bag is in the correct
position in the device, and check for leaks.
8. Open the lid
17
and remove the bag.
9. Check the welding seam. It should be a
smooth creaseless seam.
9.5
Sealing the bag
(without vacuum)
1. Proceed in the same way as for vacu-
um-packing and sealing (see “Vacuum-
packing and sealing the bag” on
page 30) until step 6.
2. Place the vacuum bagging tube in the
vacuum sealer on the front edge of the
lower sealing ring
14
.
3. Press the button
6
. The LED is lit.
The film bag is being sealed. The seal-
ing process is automatically terminated
and the LED goes out.
4. Open the lid
17
and remove the bag.
5. Check the welding seam. It should be a
smooth creaseless seam.
__347713_Vakuumierer_B8.book Seite 31 Montag, 27. Juli 2020 12:36 12