Silicon Graphics Reality Center, Installation Manual

Page: 100 / 117

Random Access Adjustment Mode
10-27 R5976280 RC3300W 19072001
Set up of the overlap are.
Each overlap area (left and right) is determined by a START position and a LENGTH (area WIDTH) (image 1).
Image 2
Image 1
Right length
Right Start
Left Start
Left length
Image overlap area
Image 1
Image 1
Image 2
Image 2
adjusted START and LENGTH for image 1 and 2
How to adjust the soft edge ?
Start position: Image 2
1. Push the cursor key é or ê to highlight 'Left Start'.
2. Press ENTER to select.
Adjust the 'Left Start' position in Image 2 of the 50%Brightness stroke by pushing the cursor keys left or right to determine the
image border. This image border is the Left start of the soft edge modulation area.
Note : when the Left start is not visible by the first image display, adjust with the cursor keys until the line becomes visible. Adjust
then the Left start to the desired position with regard to image 1.
Width of the overlap area : image 2
1. Push the cursor key é or ê to highlight 'Left Length'.
2. Press ENTER to select.
Adjust the 'Left Length' , WIDTH of the 50%Brightness stroke, in Image 2 by pushing the cursor keys left or right. Adjust towa rds
its desired position (=end of compiled overlap ).