Using Silicon Graphics Prism Modules with a Rack
007-4701-003
191
Installing the Module in the Rack
To install the module in the rack, follow these steps:
Note: Step 2 requires two people.
1.
Fully extend the left and right slide rails from the rack until they lock into place.
2.
With one person holding each side of the module, align the chassis rails of the module with
the slide rails of the rack.
3.
Slide the chassis rails into the slide rails until the chassis rails are stopped by the safety
latches.
4.
Press the safety latches on both sides of the module to fully seat the chassis rails into the
slide rails (see Figure B-8).
5.
Firmly tighten all screws (the eight screws that secure the slide rails to the rack rails).
