PCI and PCI-X Cards
007-4701-003
85
11. Insert the card into the slot by pushing the card into the connector until it is
properly seated and install the retaining screw, as shown in Figure 4-9. If you have
installed the card into one of the upper two slots, proceed to step 13.
Figure 4-9
Installing the Card and Retaining Screw
12. If you have installed a card in one of the two bottommost card slots, replace the
lower PCI/PCI-X support bracket as described in “Reinstalling the PCI/PCI-X
Support Bracket” on page 78.
13. If you removed the optional chassis rail, replace it as described in “Reinstalling the
Optional Chassis Rail” on page 79.
14. Close the top cover as described in “Closing the Cover” on page 80.
15. If you removed the module from the rack, perform the following substeps. (If you
have not removed the module from the rack, proceed to step 16.)
a.
Fully extend the left and right slide rails from the rack until they lock into place.
b. This step requires two people. With one person holding each side of the
module, align the chassis rails of the module with the slide rails of the rack.
c.
Slide the chassis rails into the slide rails until the chassis rails are stopped by the
safety latches.
