146
007-4701-003
5: Troubleshooting
Configuring a System for Multiple Xservers
Multiple Xservers allows specific subsets of the keyboards, pointing devices, and
monitors attached to a Silicon Graphics Prism system to each be managed by a different
Xserver.
Note:
The use of multiple Xservers requires ProPack
™
3, Service Pack 4 or a later release
of the software.
This section describes a relatively simple configuration. Much more complex
configurations are possible, however, and may be accomplished by extending the
instructions provided here.
Note:
When configuring multiple seats, the best method is to first attach all devices
(keyboards, pointing devices, and monitors) and configure the system with a single
Xserver. Once this is done, the configuration may be modified to assign individual
subsets of these devices to be managed by separate Xservers.
Configuring a system for multi-seat operation involves the following steps, each
described in a separate subsection below:
1.
Identify the correct event devices (that is, keyboards and pointing devices) for each
seat.
2. Create and edit an XF86Config-Nserver file for the desired configuration.
3. Point X to the newly-created
XF86Config-
Nserver file.
