Silicon Graphics 230, User Manual

Page: 39 / 148

Removing and Installing Drives
007-4263-001 23
The upper 3.5-inch front access drive bay is covered with a detachable filler plate. Follow
these instructions to detach the filler plate:
Note: Once removed, the filler plate cannot be re-installed.
• The lower 3.5-inch drive bay needs to be empty to proceed with the removal of the
filler plate; refer to the above instructions to remove the 3.5-inch drive from the
front-access bay.
• Hold the filler plate by its lower side and pull it. The action of pulling the filler plate
will break its connections to the chassis. See Figure 2-7 for an illustration of the
procedure.
Figure 2-7 Detaching 3.5-inch Drive Filler Plate