Silca Unocode 399 Plus, Operating Manual

Page: 50 / 98

Unocode 399 PLUS Operating manual - English
46 Copyright Silca 2010
5.8.7 MACHINE ZERO POINTS
With the use of regulating templates (chap.1.5 "Accessories provided", page 9) the machine provides
a ‘self-setting’ procedure. These procedures must be carefully carried out following the descriptions
and illustrations indicated below.
The table below indicates the situations where the Machine Zeroes function must be activated.
Fit the template (Z1) in the place of the cutter; (to
remove the cutte r read the instructions in
chap.7.3).
EVENT
MACHINE ZEROES CALIBRATING
CLAMPS CUTTERS
Replacement of
photocells YES YES NO
Replacement of
the electronic board YES YES NO
Replacement of
sensors YES YES NO
Replacement of
the cutter shaft YES YES NO
Replacement of
the ball screws YES YES NO