Silca Unocode 399 Plus, Operating Manual

Page: 60 / 98

Unocode 399 PLUS Operating manual - English
56 Copyright Silca 2010
5.11 M
ESSAGES
5.11.1 A
TTENTION MESSAGES
• The entered data card number is not available in the machine’s data base.
• The entered cuts cannot be carried out (see chap.5.4, page 31).
• This message appears when the cutter must be changed with one that is compatible to the type
of cuts required for the entered data card number.
• This clamp is not available in the machine’s data base.
• This cutter is not available in the machine’s data base.
• This adapter is not available in the machine’s data base.
• The entered data card number requires a type of cut that is not available in the machine’s data base.
• The minimum distance from the key stop position overlaps the first cut on the key (chap.5.9, page 52).
Data card
not available!
Non-feasible
combination!
ATTENTION!!
Install cutter:
U01W
Clamp not
available!
Cutter not
available!
Adaptor not
available!
Type of cut
not available!
MIN. Parameter of
DISTANCE FROM STOP
is incompatible with
selected card!