Unocode 399 PLUS
Operating manual - English
16
Copyright Silca 2010
4.2
F
ITTING
THE
CLAMP
TO
THE
MACHINE
To remove the clamp unit:
- loosen the grub s crew (D2) ( fig. 17) and s lide the
clamp out of the dovetail guide.
To install the clamp unit on the machine:
- slide the clamp into the dovetail guide, pushing it all
the way in, then secure it by tightening the grub screw
(D2).
These instruction s refer exclu sively to th e stan dard
clamp (V1 00). For the use of option al cl amps please
refer to the instructions provided along with them.
Fig. 17
4.3
C
UTTER
The majority of keys utilize the standard cutter for code cutting. Only in certain cases some special
keys with particular type cuts require different cutters.
To change the cutter see chapter 4.4.
4.4
C
HANGING
THE
CUTTER
1) raise the protective shield.
2) remove the cutter protective shield (i) by loosening the screw (i2).
3) slide the cutter release rod (X) into the hole located on the left side of the machines cutter shaft chassis
(fig. 18).
4) loosen the cutter locking nut (turning it clockwise) with the19 mm socket wrench (X1) provided with the
machine.
ATTENTION:
the thread is left-handed.
5) replace the cutter, then tighten the nut (turning it anticlockwise) and remove the rod from its hole.
6) place the cutters protective shield (i) back into position securing it with the screw (i2).
Fig. 18
ATTENTION:
when replacing a worn cutter with a new one or with a re-sharpened cutter consult
chap.5.7 "GAUGING", page 40.
D2
X1
X
i2
i
loosen
tighten
Summary of Contents for Unocode 399 Plus
Page 1: ...D437711XA vers 1 0 Operating manual GB...
Page 82: ......
Page 84: ......
Page 94: ...Operating manual English UNOCODE 399 PLUS Appendix XII Copyright Silca 201 0...
