Silca Unocode 399 Plus, Operating Manual

Page: 44 / 98

Unocode 399 PLUS Operating manual - English
40 Copyright Silca 2010
5.7 GAUGING
The following components on th e machine have a specific ‘self-setting’ procedure with the u se of
regulating templates (chap.1.5 "Accessories provided", page 9):
- CLAMPS
- CUTTERS
- ADAPTERS
CUTTERS do not need an automatic calibration system.
ADAPTERS provided as optionals do not require calibrating. However, if necessary adjustments can
be made to the c utting data, according to the procedures de scribed in chap.5.3.2 "ACCESSORY
FUNCTIONS FOR “COPY BY DATA CARD”", page 25.
In the circumstances listed below (see events) it may be necessary to re-set one or all of the clamps
and/or cutters that the user has in possession. This operation is semi-automatic and requires close
attention to the instructions listed below.
From the initial screen press MENU then F1 to
enable the function.
• Clamps

• Cutters

• Adapters

EVENT
MACHINE
ZEROES
CALIBRATION
CLAMP CUTTERS
Replacement of photocells YES YES NO
Electronic board replacement YES YES NO
Replacement of sensors YES YES NO
Replacement of the cutter shaft YES YES NO
Replacement of the ball screws YES YES NO
Clamp V100 replacement
(with a new one of the same type) NO NO NO
Re-sharpening of existing cutter and/or cutter
replacement (with a new one of the same type) NO YES YES
Installation of optional clamps NO YES
(if applicable)
NO
F1