Silca Unocode 399 Plus, Operating Manual

Page: 25 / 98

Operating manual - English Unocode 399 PLUS
Copyright Silca 2010 21
“Copy by data Card” procedure
1) Digit the card number (e.g.: 50):
2) Press ENTER:
Fig. 22
Fig. 23
(*) Adapter
on certain data cards provided by Silca the parameter “Adapt: B...” ind icates the type of accessory
needed to cut a key.
3) Digit the cuts.
In the cut entry field:
- The dots shown represent possible cuts. The same card can be used for a number of keys with a dif-
ferent number of cuts.
- If the key needs fewer cuts than the dots on display, just enter the partial combination (from left to right).
- in the case of
double asymmetrical cuts
, enter the cuts for both fields involved.
4) Press ENTER.
Card No
Number of cuts per side for current key
cut entry field
Symbols associated to cutting depths
symbols allowed for data
Adapter* (if required)
Clamp to use
Side 1: single cut
Side 1x2: double symmetrical cuts
Side 1 / Side 2: double asymmetrical cuts
Key Stop
Side 1
Side 1 x 2
Side 1 / Side 2
Single cut
Double symmetrical cuts
Double asymmetrical cuts