LANCER PLUS
Operating manual
2
Copyright Silca 1998
GENERAL INSTRUCTIONS
The LANCER PLUS key-cutting machine has been designed according to the specifications of the
Machine Directives.
Right from the design stage risks for the operator have been eliminated in all areas: transport, key-
cutting, regulation and maintenance.
Other risks have been eliminated by the use of protective devices for the operator.
The protective devices used are designed not to provoke further risks and, above all, they cannot be
ignored unless deliberately cut out. They do not hinder visibility of the work area.
A special adhesive label is attached to the machine warning the operator to use goggles during the
cutting operations, and this is strongly recommended in this manual.
The material used in the manufacture of this machine and the components employed during use of the
machine are not dangerous and their use complies with standards.
U
SE
The LANCER PLUS must be installed and used in the way laid down by the manufacturer.
If the key-cutting machine is used differently or for purposes different from those described in this
manual, the customer will forego any rights he may have over Silca S.p.A. Furthermore, unforeseen
danger to the operator or any third parties may arise from incorrect use of the machine.
Negligence in the use of the machine of failure on the part of the operator to observe the instructions
given in this manual are not covered by the guarantee and the manufacturer declines all responsibility in
such cases.
It is therefore essential to read the operating manual carefully in order to make the best use of
the LANCER PLUS and benefit from its potential.
F
URTHER
RISKS
There are no further risks arising from the use of the LANCER PLUS key-cutting machine.
P
ROTECTION
AND
SAFETY
PRECAUTIONS
FOR
THE
OPERATOR
The LANCER PLUS key-cutting machine is built entirely to standards. The operations for which it has
been designed are easily carried out at no risk to the operator.
The adoption of general safety precautions (wearing protective goggles) and observation of the
instructions provided by the manufacturer in this manual eliminate all human error, unless deliberate.
The LANCER PLUS key-cutting machine is designed with features which make it completely safe in all
its parts.
•
Power supply
The machine is supplied with electricity by means of an earthed plug and differential switch.
•
Start-up
The machine is started up by means of the master switch on the front.
•
Operations
The switch inbuilt into the vertical lever handle activates the motor.
•
Maintenance
The operations to regulate, service, repair and clean the machine have been devised in the simplest
possible way. There is no danger of removable parts being replaced wrongly or unsafely.
•
Machine identification
The LANCER PLUS key-cutting machine is provided with an identification label which shows the serial
number (fig. 2).
Fig. 2
(*) see ch.9 "WASTE DISPOSAL", page 21.
Summary of Contents for D411202XA
Page 1: ... Operating manual D411202XA vers 2 0 ...
Page 4: ......
