LANCER PLUS
Operating manual
14
Copyright Silca 1998
6.3
Tracers
With the tracer (N) positioned as shown in fig. 14 you can make the side ward cuts.
Loosening the locking screw (L) you can rotate the tracer and into the position shown in fig. 15 allowing you
to cut bullet wards.
ATTENTION: the calibration is not altered by the rotation of the tracer point.
Fig. 14
Fig. 15
6.4
Positioning of keys
ATTENTION: to install the keys the carriage must be positioned on the left hand side (position 1 - fig. 15).
1) loosen the thumbscrew (B) to open the jaw.
2) insert the original key in the left hand jaw aligning the shoulder with the side of the jaw (fig. 16) tightening
the thumbscrew (B) slightly.
3) to fit headclamp loosen screws (C1), (C2) and (C3) (fig. 17), slide the headclamp over the head of the
key, ensure that the bit of the key is horizontal and re-tighten the screws in the following order: (C1),
(C2) and (C3).
4) fully tighten thumbscrew (B).
5) repeat the same operation for the blank key.
Fig. 16
Fig. 17
L
N
N
B
B
C1
C2
C3
C1
C2
C3
Summary of Contents for D411202XA
Page 1: ... Operating manual D411202XA vers 2 0 ...
Page 4: ......
