Silca D411202XA, Operating Manual

Page: 23 / 30

LANCER PLUS Operating manual
Copyright Silca 1998 19
8 MAINTENANCE
ATTENTION: for repairs or replacement of parts for maintenance, the ‘CE’ mark is guaranteed only if original
spare parts provided by the manufacturer are used.
Although the LANCER PLUS key-cutting machine does not require special maintenance, it is advisable
to check and, if necessary, replace the parts subject to wear, such as: cutter, tracer and fuses.
Replacement is simple and can be carried out by the operator.
CLEANING:
keep the carriage and clamps free of chippings from the cutting operations by cleaning with
a dry brush.
▲
WARNING: DO NOT USE COMPRESSED AIR!
ATTENTION: to keep the machine well maintained we recommend using protective oil, e.g. WD40 or similar,
applied to the burnished mechanical parts. This prevents oxidation of the parts in question
(clamps, guides, carriages, etc.).
Before starting any type of maintenance (checks or replacements), read the instructions below:
• never carry out maintenance or servicing with the machine switched on.
• always remove the mains plug.
• follow all the instructions in the manual to the letter.
• use original spare parts.
8.1 Replacement of cutters
Ø
25
MM CUTTER
Operate as follows:
1) position the carriage on left (posi-
tion 1).
2) insert the locking bar (Y) to lock
drive movement.
3) using the key provided unscrew
the screw (P1) in the center of the
cutter.
4) remove the old cutter and replace
with a new one re-fixing the screw.
5) remove locking bar (Y).
Fig. 26
Ø
80
MM CUTTER
Operate as follows:
1) position the carriage on the left (position 1).
2) unscrew the three screws (T1) and remove the cover (T).
3) insert the locking bar (Y) to lock drive movement and remove the nut (O1) holding the cutter with the
spanner provided.
ATTENTION: the nut is left hand thread.
4) remove the old cutter and replace with the new one locking the nut (O1) and replacing the cover (T).
5) remove locking bar (Y).
Fig. 27
P1
Y
Y
O1
T
T1