LANCER PLUS
Operating manual
20
Copyright Silca 1998
8.2
Replacement of fuses
The fuses should always be checked with a continuity measuring instrument (tester, ohmmeter,
multimeter etc.) as a visible check may not reveal an electrical fault. Fuses must always be replaced with
others of the same type (rapid or delayed) and with the same Amps, as shown in the manual.
The LANCER PLUS key-cutting machine has two fuses (for both phases):
5 Amps rapid for machines with 220 Volt
placed in the inlet socket on the back, to protect the key-cutting machine from sudden changes in voltage
or short circuits.
It is advisable to check the fuses if the machine is not activated by pushing the master switch. Proceed
as follows:
1) switch off the master switch (R) and remove the mains plug.
2) pull the fuse board and rotate it (fig. 28).
Fig. 28
R
Summary of Contents for D411202XA
Page 1: ... Operating manual D411202XA vers 2 0 ...
Page 4: ......
