1.2.7
Batteries and charger
The MC 75.2 contains a rechargeable NiMH battery pack. When the symbol
blinks on the
display, the battery should be recharged as soon as possible.
•
Insert the charger plug into the connector on the side of the unit (
§ 1.2.4).
•
Connect the charger to the mains after checking that the mains voltage is correct. The
charge indicator (red LED)
on the front begins to blink if the battery level is very
low, then remains steady.
•
Leave the charger switched on for about 3 hours.
•
Disconnect the charger when the charge indicator on the front
goes off.
The unit can be used while the batteries are charging.
CAUTION!
The charger can be used with voltages of 230 VAC.
The charger is for indoor use only, at an ambient temperature not exceeding 40°C
(104°F).
Only use the mains adaptor supplied with the calibrator.
Replacing the battery pack:
To replace the battery pack, contact your SIKA dealer.
1.2.8
Sand and Strap
The stand gives a good angle of view when the MC 75.2 is placed on a desk.
Unfold the stand on the back of the unit and
place the MC 75.2 on a desk (
Fig.).
The MC 75.2 is supplied with an unbearable strap and two pins to attach the strap to the case.
Before attaching the strap, pass the free end through the
fixing loop as in the figure.
Feed the ends of the strap through the two slots on each
side of the case. Insert the two pins into the strap and pull
the strap to lock the pins in the case.
