Instruction Manual OilGuard 2 W
General safety points
18
14809E/2
CAUTION!
The use of aggressive chemicals when cleaning.
Use of aggressive chemicals can cause damage to instrument components.
Do not use aggressive chemicals or cleaning agents when cleaning.
Should the instrument come in contact with aggressive chemicals, clean it thoroughly
with a neutral cleaning agent.
3.2
Danger due to UV radiation
UV RADIATION!
The OilGuard is equipped with a UV LED with an emission wavelength of 280 nm.
According to the standard IEC/EN 62471 (Photobiological safety of lamps and lamp
systems), this LED is classified in Risk Group 3 (High Risk).
Exposure of longer than 3 seconds can lead to permanent damage to the eyes and
skin.
The UV LED is only accessible when the housing is open. The OilGuard is equipped with
an automatic cut-off device that puts the LED out of operation when the housing is
open.
Switch off the OilGuard when carrying out servicing duties, or wear UV goggles and
gloves.
3.3
Residual risk
WARNING!
According to the risk assessment of the applied safety directive DIN EN 61010-1,
there remains the risk of the displayed measuring values being incorrect. This risk
can be reduced with the following measures:
Use an access code to prevent unauthorized persons from changing parameters.
Perform the specified servicing duties.
3.4
Warning and danger symbols on the instrument
WARNING!
There are no warning or danger symbols on the instrument.
Users must ensure that they observe the safety measures as specified in the Instruction Man-
ual at all times when working with the instrument and its peripheral equipment, even if no
warning or danger symbols are attached to the instrument.
The following sections must be internalized:
Section 1.11
Section 1.12
Section 1.13
Section 3.1
Section 3.3
Observe safety pointers when performing the described procedures.
Observe local safety pointers.
