9
Copyright 2018, SIGMAKOKI Co.,Ltd.
HIT-S Front Panel
1) INDICATOR LED
: Shows the HIT-S condition. When it is booted with no fault, LED flashes. In case of
fault-booting, LED light is on.
2) No.Switch
: Sets the HIT-S address. Please refer to
「
2-2 Interface between HIT-M and
HIT-S(HIT-SH)
」
for further details.
3) END Switch : Sets the terminating node. Please refer to
「
2-2 Interface between HIT-M and
HIT-S(HIT-SH)
」
for further details.
4) Scale Connector
: Connects to the cable attached to the Glass Scale in use.
5) LINK Connector
: Connects to a straight LAN cable, for connecting HIT-M and HIT-S and HIT-SH.
6) RUN Potentiometer
: The current delivered when the motor is moving can be set by adjusting RUN
potentiometer above. Please refer to
「
3-1 settings for motor driving current
」
for further
details.
7) STOP Potentiometer
: The current delivered when the motor is stopped can be set by adjusting STOP
potentiometer above. Please refer to
「
3-1 settings for motor driving current
」
for further
details.
8) Connector for Stage Driver : Connects to the cable attached to the motorized stage in use.
9) Power Supply Terminal :DC +24V 1A Power Supply
10) FG Terminal
:Frame Ground Terminal. Please connect to EARTH when using.
9) Power Supply Terminal
6)RUN Potentiometer
2) No. of Switch
7) STOP Potentiometer
8) Connector for Stage Driving
10) FG Terminal
4) Scale Connector
3) END Switch
5) LINK Connector
1) INDICATOR LED
Make sure to set up and wire the cable supplying DC+24V and FG_GND to the HIT-S so
that the maximum length of cable is not longer than 2m.
For your own safety, make sure POWER is OFF before connecting every cable.