31
Copyright 2018, SIGMAKOKI Co.,Ltd.
Chapter 4: Feature
4-1.HIT mode command
4-1-1
Format of HIT mode command
This mode can operate up to 8 axes.
General format is shown below. Some formats are different depending on type of command. Please refer to each
command explanation for details.
code
：
p0,p1,p2,p3,p4,p5,p6,p7
code
Use a string to represent a command.
:
Command separation
（
Colon
（：）
）
p0
～
p7
Use(,)command to separate and assign number of slave unit 0-7. Only integer values can be
used as parameter values.
A decimal number is an incorrect command and will be responsed by NG.
+ sign can be abbreviated. +1000 or 1000 is treated as the same command.
A travel or distance parameter of 1 is equal to 0.01
µ
m.
Parameter is abbreviated when NOP
（
No Operation
）
needs to be set to the designated
slave unit number.
Note:
（
,
）
cannot be abbreviated.
（
（
（
（
Ex
）
）
）
）
,,p2,p3,p4,p5,,p7
Parameter of slave unit 0 and 1 is abbreviated.
p0,,p2,p3,p4,p5,,p7
Parameter of slave unit 1 and 6 is abbreviated.
p0,p1
Parameter of slave unit after 2 is abbreviated.
Capital or lower case characters can used. Example: h and H are both valid for the Home command.
Backspace is effective to delete a prior string.
Command string must not have leading or trailing spaces. Otherwise, the command string will not be accepted and
NG will be returned as a command error.
Immediate movement will be made in case when activation commands such as H, M, A, E, K, and J commands
are accepted normally. Unlike the SHOT mode, the activation command (G) is not needed in HIT mode. Activation
command (G) is treated as an incorrect command in HIT mode.
When issuing Q, ?, !, or I command, its status will be responded. In case which other commands are issued, ‘OK’
or ‘NG’ sign will be responded. ‘OK’ and ‘NG’ signs hereby mean ‘normal acceptance’ and ‘acceptance refused for
an incorrect command’ respectively. When other commands except Q, ?, L, !, I, O commands are issued to an
engaged slave in busy condition, ‘NG’ sign will be responded for incorrect commands, which will result in the
whole command not being executed.
When commands are issued to a disconnected slave, the command parameter of disconnected slave will be
disregarded, however, commands to the other slaves will be executed normally.