3
foam fire extinguishers, polyurethane etc., triggers an alarm to the siren and at the same time
also activates the ALARM output “ALR OUT”.
• When the siren’s supply voltage from the panel drops below 5.0 V, the “ALR OUT” output
(ALARM OUT) is activated, which can be connected to a zone of the panel, so the Control panel
is also triggered in case of alarm.
• The alarm duration from 3-G Sensor or foam detector is 90 seconds, and is independent of the
alarm duration of the control panel.
• Through “TC” input, with a very intelligent, automated process you can isolate the TAMRER
switch, the 3-G Sensor and foam detector and then you can open the cover of the siren to
change the battery or make service, without the siren sound.
• The built-in FLASH has five high brightness and low power LEDs, which are short-circuit
protected. The mode, the LEDs flash when the siren is in a standby mode is selectable.
• The FLASH continues to operate for 30 minutes after the end of the alarm, for easier locating
of the area in alarm (selectable). This function is canceled when the panel is disarmed or when
the battery voltage drops bellow 10.0V DC, provided that the TC input is connected to the
relative output of the alarm panel.
• “SIGN” Input, with selectable visual or audible confirmation of arming or disarming of the panel,
if remote control is used. This input activates the flash or the speaker, or both.
