9
Enter Setup
Siren Sound selection
To enter the siren MENU, power the siren by connecting the battery to the corresponding
terminals, taking care to use correct polarity. Then
leave the siren’s Tamper open
and press and
hold the “MENU” button until the confirmation signal (five beeps) is heard and the
“SOUND”
LED
turns on.
Now the siren is in the programming mode and the settings you can make are indicated by turning
on the corresponding siren LEDs.
To select the siren’s sound, press “SELECT” button, when the LED
“SOUND”
lights. Each time
you press “SELECT” button, the siren’s sound will change. This sound will come out of the siren’s
speaker in low volume. The last sound you hear will be the new sound of the siren.
Press “MENU” to save settings and navigate to next menu. The LED with
“FLASH”
indication
will turn on.
Select the siren’s lighting at standby mode
When the LED
“FLASH”
lights, use “SELECT” button, to select the lighting mode of the siren at
standby or
even disable it
. Each time you press “SELECT” button, will change the format of
movement of the siren’s LEDs will be the one the siren will have. The form of movement that, you
will see at the LEDs, is the one, the siren will follow.
If all the LEDs are off then, the siren will
have no lighting at standby mode.
To store this setting into memory, press the MENU button. The LED with the indication
“L/S”
will turn on.
Select the siren’s indication of arming or disarming of the system
Once the LED “L/S” lights, press
“SELECT”
button to select how they will be displayed through
siren signaling the arming and disarming of the system. Each time you press “SELECT” button, will
illuminate the LEDs
“SOUND”
and
“5/24”
or the siren will sound or both. In any of these cases
you stay, this will be the way in which the siren will signal arming or disarming of the system.
Press “MENU” to save settings and navigate to next menu. The LED
“Hi-Lo”
will light.
In factory default setting only, Flash will indicate arming and disarming of the system.
Programming
The programming of siren functions is done via the “MENU” and “SELECT” buttons, which are
placed on the siren board.
• Use the
“MENU”
button, to select the programming step you need. Each time you press
“MENU” button, you select different programming mode and this is indicated by lighting the
relative LED.
• Use the
“SELECT”
button to select the parameters of each sub “MENU”. Every time you press
“SELECT” button you change a parameter. If you have missed the desired parameter just press
“SELECT” button, as many times it is needed to return to the parameter you need.
