10
Select the siren’s activation from Tamper
As soon as the LEDs
“SOUND” & “5/24”
light press “SELECT” button to select if the siren’s
Tamper, will activate the
“Tamper”
output, but it will activate the siren, also. When the brightness
of these LEDs is low,
“Tamper”
does not activate the siren but only the
“Tamper”
output while
when the brightness of the LEDs is high, Tamper simultaneously activates the Tamper output and
the siren (factory programming).
Press “MENU” button to save your setting and navigate to next selection. The LEDs with the
indications ενδείξεις
“FLASH”
&
“Hi-Lo”
.
Select the level of the siren sound at the start of alarm (pre-alarm)
Once the LED
“Hi-Lo”
lights, press the SELECT button to select the level of the siren sound at the
start of the alarm. Each time you press SELECT button, the siren will sound with high or low sound
level (Hi-Lo). If you select low sound level, the siren will sound at low volume level for 8 seconds at
the beginning of its operation and then gives all its intensity. If you select high sound level, the
siren will sound with all its intensity in case of alarm. (factory programming)
Press “MENU” button to save your setting and navigate to next selection. The LED with the
indication
“5-24”
will light.
Select the number of siren’s activations during twenty-four hours
(maximum daily alarms)
As soon as the LED
“5-24”
lights, press “SELECT” button to select if the siren will sound every
time the alarm system is activated or only five times during a twenty-four hours (the duration of
each alarm should be longer than 20 seconds). Each time you press “SELECT” button, you will
hear the sound of the siren and will turn on or turn off all five LEDs of the siren. If you choose the
situation has light up all five LEDs, then the siren will alarm up to five times during the day. If you
chose the situation with five LEDs turned off, then the siren will operate always, repeatedly if an
alarm is given (factory programming).
Press “MENU” button to save your setting and navigate to next selection. The LEDs
“SOUND”
&
“5/24”
, will light simultaneously.
Adjusting siren sensitivity to blows
(Only in IRIS PLUS FSD)
Adjusting siren sensitivity to drilling
(Only in IRIS PLUS FSD)
When the LEDs with the indication “FLASH” & “Hi-Lo” will turn on, use the button SELECT to adjust
the siren’s sensitivity to blows which are detected by the 3-Axis accelerometer . Each time you press
“SELECT” button, you will turn on or turn off one or more of the five LEDs, which show the sensitivity
of the siren in blows.
When all five LEDs are turned off, this function is deactivated it remains,
however, active detection of inflection.
To store this setting into memory, and navigate to the next menu, press the MENU button.
The LEDs with the indication
“FLASH”
&
“Hi-Lo”
, will turn on
When the LEDs with the indication “FLASH” & “Hi-Lo” turn on, use the button SELECT to adjust the
siren’s sensitivity to drilling which are detected by the 3-Axis accelerometer. Each time you press
“SELECT” button, you will turn on or turn off one or more of the five LEDs, which show the sensitivity
of the siren to drillining.
When all five LEDs are turned off, this function is deactivated.
