6
Installation
To install the siren, please follow the steps, as described below:
1.
Select where you place the siren, this should be as high as possible, that the siren can be
easily viewed and secure.
2. Align the siren stand against the wall with the built-in spirit level, mark the fixing holes and open
them with an electric drill.
3. Fix the base of the siren to the wall using the existing brackets.
4. Pass the cable connecting the siren to the panel, from the hole which is at the base of the
siren. For maximum safety, prefer the passing of the cable in the inside of the siren to be
directly behind this hole.
5. Connect the siren to the panel, as explained in the connection terminals on page 5 and the
following wiring diagram.
6. When you finish cable connections, connect the battery to the siren. The siren can remain in
this condition until you finish the installation. The siren will start to operate normally only when
supplied with power from the alarm control panel.
Note:
When the power supply is initially applied from the panel to the siren, a short sound will
be heard as a confirmation that the siren has been activated.
7. Insert the inner cover and fasten it with four corresponding screws
8. Close siren’s external cover and fasten it with the corresponding screws.
Attention!
To power the siren from the alarm panel, you must, definitely, use wire
with diameter 0,5-0,75mm
2
. It is recommended to use cable 2x0,50 + 4x0,22 mm
2
.
