Operation
6.2 Charging
VersiCharge AC Wallbox IEC
50
Operating Instructions, 03/2021, A5E50366109-AA
Start charging
Proceed as follows to start charging:
1.
Check if the required charging point is ready for operation: The Power LED must be lit up.
2.
Register on the device.
–
If the RFID function is activated on your device, hold your RFID card in front of the card
reader. An acoustic signal is emitted.
–
Register on the device with a method supported by the operator, for example via an
app.
3.
After successful authorization, the charging unit can be used.
4.
Open the cover and insert the plug of the charging cable into the socket of the charging
unit. Make sure that the charging cable and the connecting cables are not damp or dirty.
5.
Insert the socket of the charging cable into the connector system of the electric vehicle.
Follow also the instructions of the vehicle manufacturer.
6.
The communication connection to the vehicle is established. This process can take some
time depending on the connection speed and reaction speed of the backend and vehicle.
7.
The device locks the plug into the socket. The "Vehicle connected" LED lights up.
8.
After successfully locking the connector, the charging process starts automatically. The
"Charging active" LED lights up. The vehicle is now being charged. The connectors are still
protected against unauthorized removal.
9.
The Status LEDs inform you about the current charging status.
10.
As soon as the LED bar display and the "Charging active" LED are off, the charging has been
stopped (e.g. vehicle battery full).
The LED bar display indicates that current is flowing to the vehicle and the vehicle battery is
charging. The LED bar display is off in the following cases:
•
The vehicle is not drawing power.
–
The charging unit pauses, for example, because of load management
–
The vehicle pauses the charging
•
The charging of the vehicle battery is completed.
Summary of Contents for VersiCharge
Page 1: ......
