Mounting / Installing / Connecting
4.4 Requirements for the electrical connection
VersiCharge AC Wallbox IEC
28
Operating Instructions, 03/2021, A5E50366109-AA
5.
Drive the dowels into the wall with the hammer until the dowels are flush with the wall.
6.
Mount the wall bracket onto the wall using the screws. To avoid damage to the wall bracket,
do not tighten the screws too much. Ensure that the wall bracket is mounted securely.
Figure 4-3
Mounting the wall bracket
Note
When mounting on a column/pillar, observe the applicable mounting instructions. You may
need to use different screws and tools.
4.4
Requirements for the electrical connection
The Wallbox VersiCharge is approved exclusively for fixed installation and has no device for
disconnection from the mains. The national regulations and standards must be observed
during installation of the supply line. There is no integrated circuit breaker or residual current
device; these must be installed upstream. A Type A circuit breaker is generally sufficient due
to the integrated DC fault current monitoring.
Summary of Contents for VersiCharge
Page 1: ......
