Siemens SIPROCESS GA700, Operating Instructions Manual

Page: 197 / 224

9.4 Errors
Table 9-1 Error messages
Fault message Description Measures
Invalid device
configuration
No analyzer module was detected. At least one analyzer module is re‐
quired to use the device.
Install at least one analyzer
module.
Firmware ver‐
sions incompati‐
ble
The firmware of the basic device and the analyzer modules must be com‐
patible with one another.
Please contact the service de‐
partment.
Unknown mod‐
ule type detected
An analyzer module has been detected which is not supported in the
previous firmware version.
Please contact the service de‐
partment.
Memory error
detected
A hardware fault, faulty firmware or no firmware at all has been detected
in the following analyzer modules, e.g., AM1. Possible causes:
● No firmware is present on the analyzer module.
● The existing firmware is invalid.
● The program memory is faulty.
In this case, the analyzer module starts in bootloader mode and is ready
to perform a firmware update.
If the error still exists despite the firmware update, the analyzer module
PCB must be replaced.
Please contact the service de‐
partment.
Cable fault de‐
tected
The installed analyzer modules could not be recognized correctly.
Possible causes: Faulty or incorrectly connected CAN bus cable. Check the CAN bus connec‐
tions.
Service and maintenance
9.4 Errors
Field device
Operating Instructions, 05/2015, A5E35640463-02
85