Siemens SIPROCESS GA700, Operating Instructions Manual, Page: 167 / 224

Installing
1. Preparing for installation
Figure 6-5 Cable: Preparing for installation
– Place the adapter
④
over the cable
⑥
.
– Place the clamping ring
③
over the cable
⑥
.
– Expose and remove the outer cable jacket and sheath according to the device's
geometry.
– Also expose a maximum of 18 mm from the cable outer jacket and the shielding
⑦
.
2. Installing:
Figure 6-6 Cable: Installation step 1
– Insert the cone
②
onto the male union
①
in the correct direction and according to the
type of shielding. Ribbed side toward the braided shield.
– Slide the cable
⑥
through the male union
①
.
– Slide the sheath
⑧
over the cone.
Figure 6-7 Cable: Installation steps 2 and 3
– Screw in the adapter
④
.
– Tighten the union nut
⑤
.
3. Connecting:
– Fasten the cable gland in the enclosure of the field control unit with a torque of around
50 Nm.
Wiring
6.4 Field module cable
Field device
Operating Instructions, 05/2015, A5E35640463-02
55