Siemens SIMATIC NET SCALANCE W700 Series, Configuration Manual

Page: 161 / 317

Configuring with Web Based Management
5.5 "System" menu
SCALANCE W780/W740 to IEEE 802.11n Web Based Management
Configuration Manual, 03/2015, C79000-G8976-C267-08
161
Table 2 has the following columns:
● Event
The column contains the following values:
–
Cold/Warm Start
The device was turned on or restarted by the user.
– Link Change
This event occurs only when the port status is monitored and has changed, see
"System > Fault Monitoring > Link Change".
– Authentication Failure
This event occurs when attempting access with a bad password.
– Power Change
This event occurs when power supply lines 1 and 2 are monitored. It indicates that
there was a change to line 1 or line 2. The event occurs when the PoE power supply
has failed, see "System > Fault Monitoring > Power Supply".
– Spanning Tree Change
The STP or RSTP or MSTP topology has changed.
– Fault State Change
The fault status has changed. The fault status can relate to the activated port
monitoring, the response of the signaling contact or the power supply monitoring.
– Overlap AP Detection (Only in access point mode)
This event is triggered when there is an entry in the overlap AP list.
– WDS (Only in access point mode)
The connection status of a WDS link has changed.
– DFS (Only in access point mode)
This event occurs if a radar signal was received or the DFS scan was started or
stopped.
– WLAN General (Only in access point mode)
This event occurs if a the channel bandwidth has changed.
– WLAN Authentication Log
Forwarding of the entries from the WLAN Authentication Log to the system protocol
server.
– WLAN De/Authentication (Only in client mode)
With successful or failed WLAN authentication attempts.
– iPCF Cycle Time (Only in access point mode)
Only available when the KEY-PLUG is inserted.
This event occurs if too many clients are logged on for the set iPCF cycle time or if
some clients were not reached in one cycle.
– iPCF Poll Size
Only available when the KEY-PLUG is inserted.
This event occurs if the PNIO data size is too large for transfer.
● E-Mail
The device sends an e-mail. This is only possible if the SMTP server is set up and the
"SMTP client" function is enabled.