Configuration
3.19 Telecontrol connections
Configuration - DNP3
Configuration Manual, 11/2018, C79000-G8976-C508-01
93
Figure 3-6
Connection table
The filter "1" is set in the "Starting point" column.
Example:
You have created connections with the starting points "1200", "1" and "2".
When "1" is entered in the filter cell, only the segments whose starting points start with this
partial string are shown: "1" and "1200"
Filters set in multiple columns multiply.
The selection "*" shows all existing connection segments.
The filter icon on the left in the first row ( ) shows or hides an existing filter.
The filter can be applied to all columns with an asterisk (*) in the first cell.
Note:
If you have created connections and set a filter, you cannot create any new connections.
You need to reset the filter first in order to create new connections.
Parameters
If parameters are already used by the configuration, the values are transferred to the
respective columns.
●
Name
You can change the default name of the connection segment between two subscribers.
See section "Network data" editor (Page 87) for information on this.
●
Starting point
Select the desired starting point of the connection from the drop-down list.
–
The starting point of a connection is a CPU.
●
Start subscriber
Station address of the starting point
●
Start interface
Interface of the starting point module through which the connection runs.
●
Start interface (red.)
Interface of the starting point module through which the redundant connection runs.
